Future Expansion

From Project Apollo - NASSP
Revision as of 14:19, 15 February 2007 by 210.50.104.99 (talk)
Jump to navigation Jump to search

There are plenty of candidates for future additions to the spacecraft simulated in Project Apollo after the basic historical Command/Service Module and Lunar Module are complete.

Command/Service Module

Support may be added for the proposed Block-III CSM with batteries for power in place of fuel cells, and the Block-IV CSM with batteries for power and LEM engines in place of the SPS.

In addition, the inclusion of a Block-I CSM in future versions has been discussed.

Apollo to Venus

Phases of 'Apollo to Venus' flyby plans

Phase B of the Apollo to Venus plan called for the addition of solar panels to the 'wet workshop' and the use of a Block III CSM so that the astronauts would fly the SIVB into a high altitude orbit for a year-long mission in preparation for an actual fly-by.

Phase C of the Apollo to Venus plan would use an improved version of the 'wet workshop' SIVB with a Block-IV CSM to perform the actual Venus flyby.

Wikipedia has some more information.


Long-Range Flyer

Long Range Flyer

Simple two-man rocket using fuel from the LEM. This could be used for scouting missions to sites up to around 50 miles from the main landing site, or, in an emergency, to carry two astronauts from the lunar surface to rendevouz with the CSM.


Lunar Escape System

Example of a Lunar Escape System design

The Lunar Escape System was a simpler folding rocket than the Long-Range Flyer, which would be carried in the descent stage of the LM to allow the astronauts to fly into an orbit where the CM Pilot could recover them in the event that the ascent stage failed to fire.

To save weight, the fuel tanks would be inflatable and a set of detachable legs would be used purely for launch, then left behind on the Moon. No life-support facilities would be included other than the astronauts' suits, and there would be no automated guidance; the astronauts would fly to orbit manually using a pre-programmed pitch program and lunar landmarks. Propulsion would be provided by a collection of CSM/LM RCS thrusters.


Lunar Motorbike

Lunar Motorbike in testing

Little information is available, but the 'lunar motorbike' is variously claimed to have been designed as a backup in case the LRV wasn't finished in time for Apollo 15, or planned for use on Apollo 20 in addition to or as a replacement for the LRV.


Original Saturn plans

The original Saturn-A, -B, -C and Nova designs, possibly including the earlier lunar landing plans based on multiple launches, or the single launch putting the entire CSM onto the Moon using the massive Saturn C-8 booster.

For more information see, for example, Saturn-C family and Nova family at Astronautix.com.

Project Able LEM

Project Able LEM layout

A plan to use a mirror in space to light up parts of the Vietnam jungle at night. A modified LEM with a huge flexible mirror attached would be launched into space where the mirror would unfold.

A similar plan proposed using a modified LEM to fly to Soviet satellites and spray paint over their sensors: the first space vandals.


LM/Apollo Telescope Mount

In the original Skylab plan the Apollo Telescope Mount (ATM) was to be attached to a modified LM ascent stage and launched into orbit aboard a Saturn Ib separately from an Apollo CSM carrying the Skylab crew. After a docking and crew transfer the LM/ATM would be docked with the Skylab station.


Project Icarus

Proposal to divert or destroy an incoming asteroid by launching 100 Megaton nuclear bombs on Saturn Vs.

See, for example: http://www.thespacereview.com/article/175/1 and MIT Press appear to still be selling a version of the original plan: http://mitpress.mit.edu/catalog/item/default.asp?ttype=2&tid=6840

Saturn 1

The Saturn 1 was the precursor to the Saturn 1b, using an SIV stage in place of the SIVB. The SIV was smaller, with a lower fuel capacity, and used multiple RL10 engines in place of the J2 engine on the SIVB.


Saturn 1 first stage recovery

NASA also considered recovering the first stage of the Saturn I with a paraglider.


Saturn 1b MLV

MLV Saturn 1B-5A

As part of NASA's cost-cutting plans, they studied a 'Modified Launch Vehicle' (MLV) derivative of the Saturn 1b which would replace the S1B stage with a solid rocket similar in size to a shuttle SRB. In essence this was a 1960s version of NASA's new 'Stick' launcher for the CEV.


Saturn 1b with multiple SRBs

Multi-SRB Saturn 1b replacement

Other Saturn 1b proposals would replace the S1B stage with multiple SRBs, or simply attach SRBs to the side of the S1B stage for extra thrust: that would increase payload rather then reduce cost.


Saturn INT-21

Two-stage launcher used to launch large payloads into Earth orbit. This was used for the Skylab mission.

Saturn S-ID stage

A modified S1C stage which dropped the outer four engines in a similar manner to the Altas dropping two of its engines during launch. As well as multi-stage launchers with greater payloads, it could carry 50,000 pounds to low orbit itself with no second stage.

See Astronautix.

Saturn V-24

Saturn V with stretched stages, new toriodal aerospike engines on the upper stages, uprated F-1 engines on the first stage, and four strap-on boosters with two F-1 engines each. Capable of putting over 500,000 pounds of payload into low Earth orbit.

Skylab

The NASSP 5.x Skylab sources were lost, so a new version will be required once the INT-21 support is added.

Lunar Skylab

McDonnell Douglas (Seal Beach, CA) did a study on modifying the Skylab as a moon-orbiting observatory and station.

See Astronautix.

Alternate Skylab Design - Boeing Proposal

As part of a planned 1975 manned Mars mission, Boeing came up with an alternate Skylab design that could be used to test out components for the Mars flyby spacecraft in addition to an Earth-Orbit science program.

Picture

Lunex Project

Lunex spacecraft diagram

The Lunex Project was a proposed US Air Force alternative to Apollo, which would use a lifting-body re-entry vehicle and land the entire spacecraft stack on the Moon rather than having a separate lander which rendezvoused with the orbiting return craft.



Apollo Logistics Spacecraft

This was an Apollo CSM modified to carry freight and six astronauts into orbit in support of Earth orbital Apollo Applications Program missions. Proposed launch vehicles included the Titan IIIc or Saturn Ib.


Emergency Escape Device

Emergency Escape capsule

A small capsule launched on a Titan/Agena booster which could be used to rescue the crew from an Apollo Applications Program-based space station in Earth Orbit, or permanently attached to such a station as a lifeboat.


LLRV/LLTV

The Lunar Landing Research Vehicle (LLRV)

The Lunar Landing Research Vehicle (LLRV) and later the Lunar Landing Training Vehicle (LLTV), humorously referred to as "flying bedsteads", were created to study and analyze piloting techniques needed to fly and land the tiny Apollo Lunar Module in the moon’s airless environment.

The LLRV is already available at Orbithangar using Vinka's Spacecraft.dll. More informations can be found here: [1], [2]


The Lunar Landing Training Vehicle (LLTV)

Later the LLTV was used. The LLTV incorporated changes that were the result of the initial LLRV test program and their systems were more like that of the real LM. More informations can be found here: [3], [4]

References

Here are a selection of documents with information on these spacecraft, both historical and planned: 

Saturn 5 single launch space station and observation facility. Combined mission concept evaluation Final report]
Retrieved from "http://nassp.space/index.php?title=Future_Expansion&oldid=889"